Puzzer™ ST10 Start

Puzzer™ ST10 Start


  1. Micro fillers
  2. Easy to apply and sand
  3. Fills single decrements of up to 3 cm
  4. Wet-on-wet application


Putty coat for preparing perfectly smooth walls and ceilings inside buildings before painting or paperhanging, as well as for mounting aluminium cornerbeads and jointing plasterboards.

Apply on homogeneous, clean and dry substrate. For weak substrates that are strongly absorbent or smooth and slick, use a relevant primer. Mix with water in the proportions: 0.4 L of water/1 kg of compound. Allow to stand for 5 minutes and mix again. Putty coat is ready for use by 1 hour after mixing. The setting time for a single layer (at 20ºC, humidity 65%): approx. 2 h. The temperature for the application: above +10ºC. Apply with layers from 1 to 3 mm, local defects deep up to 3 cm. Sandpaper when complete dry.